# LCR GSM options
#################
-# Enable debugging of OpenBSC library.
-# Refer to OpenBSC project for debugging options.
-# By default, debugging is turned off.
-#debug DRLL:DCC:DMM:DRR:DRSL:DNM:DSMS:DMNCC:DMNSMS:DPAG:DMUX:DMEAS
-
# Two Loopback interfaces for audio transfer between OpenBSC and mISDN.
+# They are also used for any Osmocom-BB interface, if exists.
# The first interface must provide B-channelis for each call mobile call.
# The seond interface links them to LCR.
-# Use 30 B-channels unless you need more due to many TRXs.
+# Use 30 B-channels unless you need more due to many TRXs or mobile stations.
# -> Load with: "modprobe mISDN_l1loop pri=1 nchannel=30"
# By default "mISDN_l1loop.1" and "mISDN_l1loop.2" is used.
#interface-bsc mISDN_l1loop.1
#interface-lcr mISDN_l1loop.2
+# Enable debugging of OpenBSC library.
+# Refer to OpenBSC project for debugging options.
+# By default, debugging is turned off.
+#debug DRLL:DCC:DMM:DRR:DRSL:DNM:DSMS:DMNCC:DMNSMS:DPAG:DMUX:DMEAS
+
# Give openbsc.cnf config file
# It will be located at /usr/local/lcr by default.
#config openbsc.cfg
# The database is located at /usr/local/lcr by default.
#hlr hlr.sqlite3
-# How to reject unknown subscribers.
-#reject-cause 0
-
# To keep layer 2 connection to BS11 when quitting, use this option.
# It is only usefull for developing. TRX will stay on.
# Also changes in frequency, mcc, mnc, lac while keeping layer 2 will cause
# Warning: Keeping layer 2 link may prevent emergency calls. (See below)
#keep-l2
-# Shutdown on emergency calls:
-# This option will prevent a shutdown if an emergency call is received. In
-# case of an emergency, a mobile phone may log onto you GSM network and may
-# use it to set up an emergency call.
-# The received emergency call will have 'emergency' as dialed number. But this
-# number can't be dialed on PSTN networks without chaning.
-# If you disable shutdown, be sure to provide routing of emergency calls to
-# emergency facility. If you can't do that, don't touch it!
-#no-emergency-shutdown
-
# Write BTS-Link traffic to PCAP file.
#pcapfile pcap